Filter
Top Products
Solving Problems 105
You see the message No Signal displayed.
■ Make sure the cables are connected correctly, as described in
Chapter 1.
■ If you’ve connected a video player, make sure it’s turned on and
playing.
■ If you’ve connected a laptop computer, make sure it’s set to
display on an external monitor (see page 35).
■ You may need to select the image source (the projector port to
which your equipment is connected). To switch sources, press the
corresponding
Source button on the projector or remote control
(see page 34). Allow a few seconds for the projector to sync up
after pressing the button.
You’ve connected a laptop, but the projector and laptop
don’t display the same image.
■ You have to enable your laptop to display both on its LCD screen
and through its external monitor port (see page 35).
You see the message Not Supported displayed.
■ Make sure the correct Video Signal is selected in the Video
menu (see page 70). It should normally be set to
Auto.
■ Make sure your computer’s resolution doesn’t exceed UXGA
(1600
× 1200), and the frequency is supported by the projector.
If necessary, change your computer’s resolution to a compatible
setting (see page 120).