Filter
Top Products
116 Appendix A: Projector Installation
Installing the Rear Cable Cover
If you’re mounting the projector
on the ceiling, install the rear
cable cover to enhance the
appearance of the system. To
install the cover, insert its tabs
into the slots as shown, then
push the cover against the
projector until it locks into place.
To remove the cover (when
replacing the lamp and
connecting or disconnecting
cables), release the locking tab on
the bottom of the cover as shown:
Installing Multiple Projectors
If multiple projectors are installed in one room, you can assign to each
projector a separate ID number. This lets the presenter use the remote
control to operate each projector independently (see page 48).
If you have multiple projectors installed at your place of business and
want to be able to monitor and control them over a network, see
“Managing the Projector from a Remote Computer” on page 73.
To open,
release the
locking tab
note
A remote control cable set
is available that lets you
operate the projector from
extended distances (see
page 12).