Filter
Top Products
Fine-tuning the Projector 71
24 frames per second (fps) and convert it to 60 fps for a more
natural appearance; or select
Video to prevent frame conversion.
Selecting
OFF projects interlaced signals without converting them
to progressive, which improves the look of images that contain a
lot of movement.
■ BNC Sync Termination (in the Advanced2 menu)
This setting should normally be left OFF (for TTL input). If an
analog (75-ohm) terminator is required, as for a switcher, change
the setting to
ON.
Communication Setup Options
These options let you set up the projector so it can be monitored and
controlled from a remote computer (see Chapter 5).
■ Standby Mode (in the Advanced1 menu)
Select Network ON to enable the projector to be monitored and
controlled over a network, as described in Chapter 5, when it’s in
standby mode (plugged in but not turned on).
This setting also lets you view images on an external monitor
during standby, if the monitor has been connected to the
projector’s Monitor Out port (see page 28). The projector does
not go into full sleep mode (see page 43) when this setting is in
effect.
■ Network (in the Advanced2 menu)
Used for managing the projector over a network (see Chapter 5).
If the network assigns addresses automatically, turn on
DHCP.
Otherwise, turn off
DHCP and enter the projector’s IP Address,
Subnet Mask, and Gateway Address, if applicable.
If you want to monitor the projector using a network
management utility, select
SNMP and enter at least one trap IP
address.
■ COM Port (in the Advanced2 menu)
Used for communicating with a computer running EMP Link21L
utility software. Select
RS-232C or USB, depending on the port
note
When this setting is on, you
cannot view or change the
projector’s network settings.
0
note
Press the Num button on
the remote control to use the
number keypad.
Num button
Zero