Filter
Top Products
76 Managing the Projector from a Remote Computer
Connecting and Configuring the
Projector
Before using the EMP software to manage your projector(s), you have
have to connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
Connect the cable to the ethernet port on the projector as shown.
2. Turn on the projector (see page 32).
3. Press the
Menu button on the remote control and select Network
from the
Advanced2 menu.
4. If your network assigns addresses automatically, turn on
DHCP.
To network port
Ethernet port
note
Make sure the Standby
Mode
setting in the
Advanced1 menu is off, or
you won’t be able to view or
change the projector’s
network settings.
Brightness Control High Low
:
Video
Video
Audio
Setting
Setting
User's Logo
User's Logo
Adv
Adv
anced1
About
About
Reset All
Reset All
Projector ID
Network
Reset
Execute
: 1
[Menu]: Exit[ ]: Enter
Enter
[ ]: Select
Select
Eff
Eff
ect
Adv
Adv
anced2
COM Port
BNC Sync Termination
:
ON OFF
:
Set
Set
RS-232C USB
Auto setup
ON OFF
:
Select Network