Filter
Top Products
Displaying and Adjusting the Image 33
3. Press the red PPower button on top of the projector—or press
the P
Power button on the remote control.
(If this is your first time using the remote control, make sure the
batteries are installed and the power switch on the side of the
remote is turned on; see page 46.)
The Ppower light flashes green as the projector warms up, and an
image begins to appear after about 30 seconds. When the
Ppower light stops flashing and remains green (in about a
minute) the projector is ready for use.
4. If you’ve connected a Windows-based computer to the projector,
you may see a New Hardware Wizard saying your computer has
found a plug-and-play monitor; if so, click
Cancel.
Turn on
remote
Power button
warning
Never look into the lens
when the lamp is on. This
can damage your eyes, and is
especially dangerous for
children.