Filter
Top Products
22 Using Memory Cards
After the CX6400 reads the card, if it finds any images saved in a compatible
format (see note below), you see the following screen:
5. Press the button next to
OK (shown on the screen).
To remove the card, pull it straight out of its slot. On a Macintosh, drag the card
icon on your desktop to the
Trash icon before removing the card.
Caution:
Do not remove the card or turn off the CX6400 while the memory card light is flashing,
or you may lose data on the card.
Note:
Your image files must meet these requirements:
Using Your CX6400 as a Card Reader
You can use your CX6400 as an external card reader, letting you copy images from
a card to your computer, or vice versa. To use this feature with Windows
®
98 or
Me, make sure you’ve already installed your CX6400 software as described on the
Start Here sheet (this automatically installs the necessary USB storage driver).
1. Make sure your CX6400 is turned on and connected to your computer.
2. Insert a memory card as described in the previous section. (If you’ll be copying
images to the card, make sure the card’s write-protect tab, if it has one, is set to
allow writing on the card.)
Note:
If this is your first time inserting a card, see “Using EPSON CardMonitor” on
page 23 to set up EPSON CardMonitor.
File format JPEG or TIF format image files (supports Exif version 2.1/2.2)
Media format DCF (Design rule for Camera File system) version 1.0
Image size Vertical 120 to 4600 pixels, horizontal 120 to 4600 pixels
Found Images...
Total XXX OK