Filter
Top Products
If one of your hard disk drives is already installed in the
computer, foll
ow the steps under “Removing a Hard Disk From
the Vertical Position” on page B-24 to remove it. Then set the
jumpers on both drives while they are out of the computer. The
steps in that section tell you which instructions to follow next.
Note
If you are removing one hard disk drive and leaving one in
your computer, be sure to set the jumpers on the remaining
drive to indicate that you have only one hard disk drive. See
the table above for the jumper settings. Then follow the
instructions under “Removing a Hard Disk From the Vertical
Position’ on page B-24 so you can access the jumpers on the
drive.
Installing a Hard Disk in the Vertical Position
Follow the instructions in this section to install (or reinstall) a
hard disk drive in the vertical mounting position. You may need
to perform the following procedures:
0
Remove the mounting frames from a new hard disk drive
0
Remove the mounting plate from the computer and connect
it to the drive
0
Install the drive
0
Connect the drive and power cables.
If you are installing a new drive in the vertical mounting
position, you should follow all of the steps in this section. If you
are reinstalling a drive that you previously removed from this
position, see “Installing the Drive” on page
B-12.
Installing
and
Removing Disk Drives
B-7