Filter
Top Products
Press N and
Enter
if you want the diagnostics program to
continue when an error occurs.
The next option is:
Error logging (Y/N) ?
N
Press
Y and Enter
to record the errors that may occur during the
test. See “Error Logging,” below, for details.
Press
N
and
Enter
if you do not want to create the log. (N is the
default setting.)
Note
If you press
N at the Wait
on
press
Y
for
Error
error
prompt, you should
logging so you can review any errors
that may occur during the tests.
You may see a prompt requesting additional information the
program needs to perform the test(s).
If you selected Continuous testing, the diagnostics program
needs no additional information. Instead, you see this message in
the Run time parameters window:
Test mode:
Continuous
If you selected Timebound testing, you see this prompt:
Period
:00l hr 00 min
To specify the amount of time you want to run the test(s), type
the number of hours (from 000 to 999), and press
Enter.
Then
type the number of minutes (from 00 to 59), and press
Enter.
You can use the backspace key to make corrections.
Perfoming System Diagnostics
C-S