Filter
Top Products
You can stop testing at any time and return to the main menu by
holding down Ctrl and pressing
Break.
The program completes
the current test before it stops.
You must enter certain parameters to run the hard disk and
diskette drive tests. If you use
F3
to select these tests, the
program prompts you for the parameters immediately. If you
use
F4,
the program prompts you for the parameters during the
first pass of the test. If you perform the tests more than once, the
program uses the same parameters for each pass.
If you selected Passbound testing, the program displays the pass
number on the right side of the screen above the Run time
parameters window. For example:
Pass :
00001
If you entered
Y at the Wait
on error
prompt, the
program pauses if an error occurs. When you press
Enter,
the
program continues testing.
Note
Tests selected using the F3 and F4 keys remain selected until
you cancel the selection. Be sure to press
F5
to cancel all
selections when you are finished running each set of tests.
Performing System Diagnostics
C-9