Filter
Top Products
Printing
Problem
Solution
The position of the
printout is not
what you expected.
Text is printed on the
same line.
Text is printed with
an extra blank line in
between.
Text is printed with
an extra blank line in
between, even after
setting the auto line
feed setting to off.
Printing starts too
high or too low on the
Page.
A line feed signal is not being sent at the
end of each line of text. Check the
AUTO LINE FEED setting in SelecType,
and set it to on. Refer to 3-11.
Two line feed signals are probably being
sent. Check the AUTO LINE FEED
setting in SelecType and sent it to off.
Refer to 3-11.
Your interface cable may not be
configured correctly. Disable the AUTOcc-
FEED XT signal of your interface.
The loading position may be set up
incorrctly. Use micro-adjustment to
adjust the loading position. Refer to
3-21. If the problem persists, check the
top margin set by your application
software are adjust it if necessary.
7-10 Troubleshooting