Filter
Top Products
Problem
Solution
Continuous paper
does not feed
properly.
(continued)
Regular gaps appear
in the printout.
Skip over perforation
is set, but the
perforation does not
fall in the center of
the skip.
You may have pressed the LOAD/EJECT
button with continuous paper already
set at the loading position. Pressing the
LOAD/EJECT button with continuous
paper already loaded in the printer
causes the paper to be ejected. If this
happens, press the LOAD/EJECT button
once more to reload the paper. Refer to
2-14.
The skip over perforation may be set
with SelecType. Enter SelecType and
turn off the skip over perforation
feature. Refer to 3-19.
The page length for continuous paper
may not be set correctly. Change the
page length with your software
program. You can also use the ESC C n
or ESC C 0 n command to specify the
page length.
The loading position of the paper may
be too high or too low. Use the
micro-adjustment feature to reset the
loading position so that the perforation
is centered within the skip area.
7-18 Troubleshooting