Filter
Top Products
1-3
Connecting Your Printer and Installing Drivers | 1-3
3. Make sure you set any jumpers or DIP switches on the card. See the
card’s documentation for details.
On the FireWire card, make sure DIP switch 10 is set to
ON
(advanced
mode).
4. Slide the interface card along the slots on both sides of the
compartment. Push it in firmly to fully insert the connector into the
printer’s internal socket.
5. Secure the interface card in the slot with the two screws included with
the card.
6. Make sure the printer has been turned off using the
Power
button.
Then plug in the power cord.
7. To initialize the EpsonNet Internal Print Server, turn on the printer
while holding down the status sheet button on the card for about 5
seconds.