Filter
Top Products
Problem Solving
104
Lamp Error
Lamp Failure
Check the following two points.
• Take out the both lamps and check if they are cracked.
• Clean the air filter.
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and
contact Epson. s p.116
If it is cracked: Replace it with a new lamp, or contact Epson for further advice s p.116. If replacing the
lamp yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is
replaced).
When using at an altitude of 4900 ft (1500 m) or more, set High Altitude Mode to On. s p.73
Set Direction to Pointing Down or Pointing Up when the projector is installed to project images downward
or upward. s p.73
Filter Airflow Error Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
If the error continues after checking the points above, stop using the projector, disconnect the power cable
from the electrical outlet, and contact Epson. s p.116
Auto Iris Error
Cinema filter error
Shutter Error
Power Err. (Ballast)
Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.116
Status Cause Remedy or Status