Filter
Top Products
Limitation of the Number of the Target Projectors when Using Multiple Projectors
57
Setting the Remote Control ID
Procedure
A Set the remote control ID switch to On.
B While holding the [ID] button, press a number button to
select a number to match the ID of the projector you want to
operate.
Once this setting has been made, the projector that can be operated by
the remote control is limited.
The remote control ID setting is saved in the remote control. Even if the
remote control batteries are removed to replace them, the stored ID
setting is retained. However, if the batteries are left out for a long time, it
is reset to the default value (ID0).