EVGA 122-M2-NF59-AX Computer Hardware User Manual


 
EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
Page 41
Temperature Values
This option is used to set which display device will be used first when your PC starts up.
System
The temperature of the system
CPU
The temperature of the CPU
Board
The temperature of the motherboard
Voltage values
CPU
The voltage of the CPU
Memory
The voltage of the Memory
+3.3V
The voltage of the +3.3V
+3.3V Dual
The voltage of the +3.3V Dual
+5V
The voltage of the +5V
nForce MCP
The voltage of the nForce MCP chip
nForce SPP
The voltage of the nForce SPP chip
HT CPU <-> nForce SPP
The voltage of the HT between the CPU and the nForce SPP chip
+Vbat
The voltage of +Vbat
Fan Speed values
CPU Fan Speed
The CPU fan speed
MCP Fan Speed
The MCP fan speed
Sys Fan Speed
The system fan speed
Load Defaults
The BIOS defaults sets the basic system functions that ensure system stability. If the
system is NVIDIA LinkBoost™ enabled, the default settings are the LinkBoost settings.
If your computer cannot POST properly, you should load the Defaults to restore the original
settings.
Set Password
The password can be used to start the system or modify the CMOS settings. When you
select the Set Password option, the following message will appear in the center of the
screen:
Enter Password:
Enter your password, not exceeding 8 characters, then press <Enter>. The password you
enter will replace any previous password. When prompted, key in the new password and
press <Enter>. If you do not want to set a password, just press <Enter> when prompted to
enter a password, and in the screen the following message will appear. If no password is
keyed in, any user can enter the system and view/modify the CMOS settings.
Password Disabled!!!
Press any key to continue…