Filter
Top Products
EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
Page 64
FCC Compliance Information
This device complies with FCC Rules Part 15, Operation is subject to the following two conditions: This
device may not cause harmful interference, and this device must accept any interference received,
including interference that may cause undesired operation. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the manufacturer’s instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 1) Increase the separation between the equipment
and signal source, 2) Connect the equipment to an outlet on a circuit different from that to which the signal
source is connected, 3) Consult the dealer or an experienced computer technician for help. The use of
shielded cables for connection of the monitor to the graphics card is required to ensure compliance with
FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
CE Compliance Information
EMC Directive 89/336/EEC And Amendment 92/31/EEC, Class B Digital Device EN 50081-14, Generic
Emissions Standard for Residential, Commercial and Light Industrial Products (EN 55022/CISPR 22,
Limits and Methods of measurement of Radio). (EN 55022/CISPR 22, Limits and Method of
Measurement of Radio Interference Characteristics Information Technology Equipment) Warning: This is a
Class B product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measure. EN 50082-1, Generic Immunity Standard for
Residential, Commercial and Light Industrial Products (IEC 801-2, IEC 801-3, IEC 801-4)
Software License Agreement
This EVGA software (the “software”) is copyrighted by EVGA.com CORP and is protected by US law. All
rights reserved. The purchaser is granted a license to use the software only, subject to the following
restrictions and limitations:
1. The license is for the original purchaser only, it is transferable so long as all items bundled with the
software are transferred to the same individual as a sale (e.g. all software, manuals, hardware, etc.)
2. The original purchaser may use the software on a single computer owned or leased by the original
purchaser. You may not use the software on more than a single machine, even if you own or lease
more than one machine, without the written consent of EVGA
3. The original purchaser may make backup copies of the software for his or her own use only,
subject to the use limitations of this license.
4. The original purchaser may not engage in, nor permit third parties to engage in, any of the
following:
• Providing or disclosing the software to third parties
• Providing use of the software in a computer service business, network, time-sharing
network
• Making alterations or copies of any kind in the software (except as permitted above)
• Attempting to un-assemble, de-compile or reverse engineer the software in any way
• Granting sublicenses, leases, or rights in the software to others
• Making copies, or verbal or media translations, of the user’s guide
• Making telecommunication data transmissions of the software
Trademark Information
2001-2005 EVGA.com CORP. EVGA, the EVGA logo and combinations thereof are trademarks of
EVGA.com CORP. NVIDIA, NVIDIA logo, nForce are registered trademarks and/or trademarks of NVIDIA
Corporation in the United States and other countries and are used under license to EVGA.com CORP
from NVIDIA Corporation. AMD is a registered trademark of Advanced Micro Devices. All brands and
companies are trademarks or registered trademarks of their respective companies. EVGA reserves the
right to terminate this license if there is a violation of its terms or default by the Original Purchaser. Upon
termination, for any reason, all copies of Software and materials, must be immediately returned to EVGA
and the Original Purchaser shall be liable to EVGA.com CORP for any and all damages suffered as a
result of the violation or default.
APPENDIX 2
COPYRIGHTS, TRADEMARKS, NOTICES