Filter
Top Products
F
filemarks
long filemarks 2-17
short filemarks 2-18
formats, data
description 1-5
front bezel 1-9
G
gap blocks 2-16
gap bytes 2-15
gap tracks 2-16
ground 6-14
ground tab and hole 1-11, 6-14
H
heads
description 1-14
position of relative to tracks 2-8
heat dissipation requirements 6-17
helical scan recording 2-2
high-speed search 6-3
I
IDRC algorithm
See compression
installation requirements 4-2
interface card 1-16
L
label locations 1-10
LBOT 2-19
LEDs
general description of 1-10
tape drive states represented by 4-11, 4-13
LEOT 2-19
load time 4-15
loading data cartridges 4-14
logical blocks
compression 2-13
description 2-13
packing into physical blocks 2-13
logical format 2-12
M
maintenance requirements 4-17
mean time between failures
assumptions for 6-8
restrictions for 6-9
test conditions for 6-8
value for tape drive 6-7
messages supported 5-2
Monitor port 1-12
motion threshold
during a read operation 3-8
during a write operation 3-5
mounting requirements 4-3
MTBF
See mean time between failures
N
noise specifications 6-20
O
operating environment 6-16
operating the tape drive 4-11
P
packing materials 4-19
particulate contamination limits 6-17
PBOT 2-19
PEOT 2-19
performance specifications 6-2
physical block counts 2-20
physical blocks
description 2-9
packing logical blocks into 2-13
physical description 1-9
physical format 2-3
pin assignments
differential SCSI connector 4-8
power connector 6-13
single-ended SCSI connector 4-10
power connector 1-11, 6-13
power specifications 6-12
power-on mode 4-11
I-2 EXB-8205 and EXB-8505 510504
(Standard and XL)
Index