Filter
Top Products
Operation, cont’d
MVX Plus 128 VGA Matrix Switchers • Operation
3-24
PRELIMINARY
Example 7: Saving a preset
In the following example, the current confi guration is saved as a preset. The steps
show the front panel indications that result from your action.
1. Press and release the Esc button (fi gure 3-40).
C O N T R O L
PRESET
ENTER
ESCVIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-40 — Clear all selections
2. Press and hold the Preset button for approximately 2 seconds until it blinks
(fi gure 3-41).
PRESET PRESET
1
2
3
Press and hold the Preset button until it blinks.
2 seconds
= Blinking button
All input buttons with assigned presets light red.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Red
(Preset Assigned)
Unlit
(No Preset Assigned)
Figure 3-41 — Enter Save Preset mode
3. Press and release the input or output button for the desired preset
(fi gure 3-42).
C O N T R O L
PRESET
ENTER
ESCVIEW
INPUTS
1
2
3
4
5
6
7
8
9
The Enter button blinks to
indicate the need to save the
preset.
The Preset button continues
to blink.
= Blinking button
Press and release the Input 1 button.
The button blinks red to indicate that this
preset number is selected but not saved.
Figure 3-42 — Select the preset