Extron electronic SW AV Switch User Manual


 
Remote Control, cont’d
SW AV Series Switchers • Remote Control4-4
Command/Response Table for SIS Commands
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Input selection
Select video and/or audio input
X1
!In
X1
•All Select input
X1
entire channel.
Example (SW 4AV): 3! In003•All Select input 3 video and audio.
Example (SW 6SV): 5! In005•All Select input 5 video only.
Example (SW 12A RCA): 10! In010•All Select input 10 audio only.
Select video input only
X1
&In
X1
•Vid Select input
X1
video only (audio
breakaway).
Select audio input only
X1
$In
X1
•Aud Select input
X1
audio only
(audio breakaway).
Input video sensing
Request all inputs’ status 0S Sig•
X3
1
X3
2
•...•
X3
n
Each
X3
response is the signal
status of an input, starting from
input 1; n is the maximum
number of inputs for this model.
Example (SW 6V): 0S Sig•1•1•1•0•1•0 The input signal is present on
inputs 1, 2, 3, and 5. No signal is
present on inputs 4 and 6.
Request an individual input’s status
X2
S
X3 X2
’s signal status =
X3
.
Video mute
Mute video 1B Vmt1 Output no video signal.
Unmute video 0B Vmt0 Output selected video input.
Read video mute B
X4
Mute status =
X4
.
With the exception of the audio gain and attenuation commands, the SIS
commands are not case sensitive.
Symbol definitions
Input and output numbers in commands may be entered as either 1-, 2-, or 3-
digit numbers. All input and output numbers are specified as 3-digit numbers
in the response.
= CR/LF (carriage return/line feed) (0x0D 0A)
= CR (carriage return, no line feed)
= space
X1
= Input number 0 through the maximum number of inputs (0 = muted output)
X2
= Input number 1 through the maximum number of inputs
X3
= Input signal status 0 = no signal detected, 1 = signal detected
X4
= Off/On status 0 = off, 1 = on
X5
= Gain/attenuation -18 dB to +24 dB, each step = 1 dB
X6
= Gain value Numeric dB value, 0 to 24
X7
= Attenuation value Numeric dB value, 1 to 18
X8
= Front panel switch mode 1 = normal (manual mode, 2 = autoswitch mode
X9
= Controller firmware x.xx