Filter
Top Products
Installation, cont’d
TPX 88 Matrix Switchers • Installation2-8
When making connections for the TPX 88 A from existing audio cables, see
figure 2-6. A mono audio connector consists of the tip and sleeve. A stereo
audio connector consists of the tip, ring and sleeve. The ring, tip, and sleeve
wires are also shown on the captive screw audio output connector diagram,
figure 2-5.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring (
-
)
Tip (+)
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Figure 2-6 — Typical audio connectors
Remote port configuration
The Remote port is a 3.5 mm, 5-pole captive screw connector for serial
RS-232/RS-422 control of the TPX 88. Wire the connector as shown in figure 2-7
and connect a host device, such as a computer, touch panel control, or RS-232
capable PDA.
GND
TX-
TX +
RX -
RX +
RS-232 FunctionPin
Gnd
—
TX+
—
RX+
Gnd
TX-
TX+
RX-
RX+
Signal ground
Not used
Transmit data
Not used
Receive data
Gnd
TX-
TX+
RX-
RX+
Signal ground
Transmit data (-)
Transmit data (+)
Receive data (-)
Receive data (+)
RS-422 Function
RS-232
RS-422
RS-232
RS-232
Settings
RS-422
Settings
RS-422
Figure 2-7 — Remote connector
RS-422 implementation may vary between computers or controls systems.
Connect the control cable as shown in figure 2-7. If the serial communications
link with the TPX switcher does not work, try reversing the polarity of the TX
and RX signal lines.
Set Remote Configuration DIP switches 1 and 2 either both down to select RS-422
serial control protocol or both up to select RS-232. DIP switch 3 should always be
up.
If desired, connect an MCP 1000 remote control panel master unit or MKP 2000 or
MKP 3000 remote control panel to the switcher’s Remote connector. You can also
connect an MKP 1000 remote keypad or MCP 1000 slave unit to the MCP 1000
master unit. Refer to the connected device’s manual for details.
See chapter 4, Programmer’s Guide, for definitions of the SIS commands and
chapter 5, Matrix Software for details on how to install and use the control software.