Filter
Top Products
Remote power
The XTP T USW 103 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION: XTP remote power is intended for indoor use only. No part of the network
that uses XTP remote power should be routed outdoors.
Power injector
To power the XTP T USW 103 remotely with an XTP Power Injector, power one device
locally (see Local power on page 8) and connect an XTP Power Injector to the XTP cable
run along the XTP ports (see the XTP Power Injector User Guide for more installation
information).
NOTE: The power injector provides remote power up to 330 feet with a CATx cable with
24 AWG wire.
POWER
12V
2
1.0 A MAX
G
1
SIG LINK
LAN
AUDIO
RGB HDMI HDMI
CONTACT
Rx
G
G
Tx
RS-232 IR
Rx
Tx
RS-232
T
x
Rx
3
1
23
R
REMOTE
INPUTS
XTP OUT
OVER XTP
POWER
12V
HDMI
--A MAX
Rx
GTx
RS-232 IR
RL
RxTx
-+ -+
1
2
AUDIO
OFF
ON
AUDIO
S/PDIF
RESET
LAN
SIG LINK
XTP IN
OVER XTP
OUTPUTS
RELAYS
ACT LINK
SIG LINK
XTP IN
XTP
PWR
XTP PWR
100-240V
50/60 Hz
---A MAX
Extron
XTP T USW 103
XTP Switcher
Extron
XTP R HDMI
XTP Receiver
Extron
XTP PI 100
XTP Power
Injector
CATx Cable
REMOTE
POWER
HDMI
HDMI
Display
Blu-Ray
12V Local Power
Supply
Figure 9. Typical Pont-to-point Application with Remote Power
Direct power from an XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (refer to the user guide of the XTP matrix switcher for more details).
To manage available power from the XTP matrix switcher, use the XTP System Configuration
Software (see XTP System Configuration Software on page 20).
XTP T USW 103 • Installation 9