Filter
Top Products
Selecting an Input
To select an input from the front panel, perform the following action:
Press the input selection button that corresponds with the desired rear panel input
connector. The corresponding LED lights to indicate the active input.
Setting the Front Panel Lockout Mode (Executive Mode)
To enable or disable front panel lockout mode, press and hold (for about 5 seconds) input
buttons 1, 2, and 3 simultaneously until all front panel LEDs blink three times.
In front panel lockout mode, input selection from the front panel is disabled, but RS-232 and
USB control and contact closure are still available.
Enabling Auto Switch Mode
Press and hold (for about 3 seconds) inputs 1 and 3 simultaneously until the Auto Switch
LED lights. In auto switch mode, the switcher automatically switches to the highest
numbered input with an active video signal.
NOTE: Setting auto switch mode to prioritize the lowest numbered active input can be
done only with SIS commands (see Auto switch mode SIS commands on page 16).
Normal switch mode is the default switch mode.
The audio input selected depends on the audio input selection setting (see Audio input
selection SIS commands on page 16).
Enabling Normal Switch Mode
Press and hold (for about 8 seconds) inputs 1 and 2 simultaneously until the Auto Switch
LED turns off. This is the default switch mode.
EDID
To manage EDID on the XTP T USW 103, use the XTP System Configuration Software
(see XTP System Configuration Software on page 20) or SIS commands (see SIS
Configuration and Control on page 13). The XTP T USW 103 can record and save EDID
in a user memory location, select a pre-defined EDID, or use EDID from a display connected
to a receiver. EDID stored in the user memory location can come from the display connected
to a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher
using the XTP System Configuration Software.
XTP T USW 103 • Operation 11