Filter
Top Products
Auto-input Switching section
Auto-input switching — Click the Enable Auto-Input Switching check box to enable
auto switch mode. Two settings are available for this mode.
Click the Priority to highest active input number radio button to automatically
switch to the highest numbered active input.
Click the Priority to lowest active input number radio button to automatically
switch to the lowest numbered active input.
Factory reset
Click the Factory Reset button to reset the transmitter to factory settings except for
firmware.
NOTE: This is the same as the EZXXX SIS command.
Device Information panel
The Device Information panel displays device information
and settings.
General Information section
Model — Displays the device model.
Firmware version — Displays the full firmware version.
Signal Information section
Selected input — Displays the input number of the
currently selected input.
Auto-input switching — Displays the On or Off status of
auto switch mode.
Signal present — Displays the signal presence of all three
inputs.
HDCP — Displays the HDCP status of inputs 2 and 3.
Audio Information section
Selected audio input — Displays the number of the
currently selected audio input.
Analog audio gain — Displays the analog audio gain in dB.
XTP T USW 103 • XTP System Configuration Software 29