Filter
Top Products
Error Responses
When the XTP T USW 103 receives an SIS command and determines that it is valid, it
performs the command and sends the corresponding response to the host device. If the
command is determined invalid or contains invalid parameters, the switcher returns an error
response to the host. The error response codes are:
E01 = Invalid input number E12 = Invalid port number
E06 = Invalid switch attempt in this mode E13 = Invalid parameter
E10 = Invalid command E14 = Not valid for this configuration
E11 = Invalid preset number E17 = Invalid command for signal type
Using the Command and Response Table for SIS Commands
The command and response tables begin on page 16. Figure 11 shows the hexadecimal
equivalent of ASCII characters used in the command and response tables.
NOTE: Upper and lowercase text can be used interchangeably unless otherwise stated.
ASCII to Hex Conversion Table
•
Space
Figure 11. ASCII to Hexadecimal Conversion
XTP T USW 103 • SIS Configuration and Control 14