Filter
Top Products
61
4
● Boot Time Diagnostic Screen
This item sets whether to display the self diagnostic (POST) screen at boot or reboot.
- Disabled (Initial value)
The FUJITSU logo is displayed at boot or reboot.
- Enabled
The self diagnostic (POST) screen is displayed at boot or reboot.
To confirm BIOS messages from an extension card, select [Enabled].
● Preboot Execution Environment
This item sets whether to preboot from the network server.
- Disabled (Initial value)
Boots the computer from its hard disk drive, CD-ROM drive, or floppy disk drive.
- Enabled
Starts the computer from a network server. If the computer is rebooted after this item is
set to [Enabled], “PXE” is added to “Boot Device Priority.”
To boot from the network server, an installation server system conforming to Network PC
System Design Guidelines Version 1.0b is required.
● Delay Time for ATA/ATAPI Drive
This item sets the wait time until the computer automatically identifies the ATA/ATAPI
drive.
- None
The computer boots automatic identification as soon as it launches.
- 3, 5, 10, 15, 30 seconds (Initial value: 3 seconds)
The computer boots automatic identification after a preset time.
If the computer does not identify the connected ATA or ATAPI drive properly, extend the
preset time.
Point
Point
Point