Filter
Top Products
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Site Planning-
Copyright 2013 FUJITSU LIMITED P3AM-4822-12ENZ0
4
About this Manual
Organization
This manual is composed of the following four chapters:
● Chapter 1 Hardware Configurations
This chapter describes the main components and the relative optional products that are installed in the
ETERNUS DX80 S2/DX90 S2 Disk storage system.
● Chapter 2 ETERNUS DX Disk Storage System Installation
This chapter describes the installation specifications, the installation environment, and the power
requirements.
● Chapter 3 Connections
This chapter describes the configuration for each interface to connect to the ETERNUS DX80 S2/DX90 S2
Disk storage system.
● Chapter 4 Rack and Optional Product Installation
This chapter describes the requirements for rack installation.
This chapter also describes the standard installation rules (installation locations and installation order) of
the optional products before shipment from the factory when the optional products are purchased with the
ETERNUS DX80 S2/DX90 S2 Disk storage system at the same time.
Naming Conventions
■ Abbreviations used in this manual
• "ETERNUS DX Disk storage system" refers to the ETERNUS DX80 S2/DX90 S2 Disk storage system.
• "CA" refers to a host interface module that is used in an ETERNUS DX Disk storage system to connect to a
server.
• "Host Bus Adapter (HBA)" refers to the interface module that is normally used by the server to connect to
ETERNUS DX Disk storage systems.
An "FC card", "LAN card", "Network Interface Card (NIC)", "Converged Network Adapter (CNA)", or "SAS card"
may be used instead, depending on the server and interface.
• Trademark symbols such as ™ and ® are omitted in this document.