Fujitsu FS-1104AU/1104MU Switch User Manual


 
25
11-1-4. Plug and Play Data (EDID Data) Settings
*Note. The power of the monitor must be ON to set the EDID data.
(1) Enter MODE-1 of the Hotkey mode.
(2) Press <N> or the right button of the mouse to enter the Customer mode.
(3) Move the cursor to DEFAULT MONITOR (default setting) on the right of MONITOR TYPE
or to the product name of the monitor and press <ENTER>. When <ENTER> is pressed,
"SCANNING" is displayed, and the KVM Switch reads the EDID data from the monitor that
is connected to the [CONSOLE] port and sets the EDID data.
*Note. When the EDID data is set correctly, the name of the monitor or "PNP MONITOR" is
displayed. When the monitor is not a Plug and Play monitor, the monitor display is
OFF, or the monitor is not correctly connected, the EDID data cannot be read and the
monitor is set as DEFAULT MONITOR (15 inch monitor, resolution: 1024x768) for the
KVM Switch.
(4) Press <P> or the left button of the mouse to return to the SERVER SELECTION screen. If
<ESC> or the right button of the mouse is pressed without pressing <P>, the Hotkey mode
ends and the normal screen can be returned to.)
(5) Press <ESC> to end the Hotkey mode and return to the normal screen.
*Note. The EDID data can also be set by pressing the [RESET] switch while the monitor is
connected (and the power of the monitor is ON).