Filter
Top Products
32
ii. When a cascade connection is used
The server can be selected by pressing the [ServerSelection] switch.
When this switch is pressed, servers without power can also be selected.
When M1 (as shown in the diagram below) is selected and the [ServerSelection] switch (right)
is pressed, from S1 to S8 for the previously selected server can be selected. (S1 is the default
setting)
In addition, when M1 is selected and the [ServerSelection] switch (left) is pressed, M8 is
selected.
Key typer (server quick selection) is not enabled by pressing the [ServerSelection] switch for a
long time.
When ports in a cascade connection are selected by operating the front panel of the master
and the right and left [ServerSelection] switches are pressed at the same time, the selection is
changed to the connected cascade destination. After the selection is changed to the connected
cascade destination, the server for the cascade destination can be selected by operating the
[ServerSelection] switch.
By pressing the right and left [ServerSelection] switches at the same time one more time, the
selection is changed to the master.
In addition, only server selection on the cascading side can be performed by [ServerSelection]
switch operation on the cascading side.