Filter
Top Products
1-9
Abrasion
counter
The abrasion counter is displayed when
Stop
is pressed in the
initial screen.
The abrasion counter disappears when:
• The next scanning starts.
• The valid switches are pressed.
• The error is cleared.
The abrasion counter is not displayed if
Stop
is pressed during
blinking.
The abrasion counter displays the accumulative number of read
document.
This counter can be reset to zero by following the procedure
shown in Chapter 7 (page 7-7).
Simplex reading mode
<IPC-2 pre-set mode>
Duplex reading mode
When IPC-2 pre-set mode is set, an asterisk ( ✳ ) is displayed.
The method of IPC-2 pre-set mode is shown in setup mode.
<Abrasion counter>
SF A4 40 0 L. >
X
XXXXX
S
✳
FA4 40 0 L. >
D
✳
FA4 40 0 L. >
DB
L. >
03-Chap. (1) 98.2.20, 10:49 AM9