Filter
Top Products
1-13
Abrasion
counter
The abrasion counter is displayed when
Stop
is pressed in the
Ready screen.
The abrasion counter displays the accumulative number of read
document.
This counter can be reset to zero by following the procedure shown
in Chapter 7 (page 7-7).
The reading counter or abrasion counter disappears when:
• The next start commnad is issued.
• The valid switches are pressed.
• The error is cleared.
When IPC-2 pre-set mode is set, an asterisk ( ✳ ) is displayed.
The method of IPC-2 pre-set mode is shown in setup mode.
<IPC-2 pre-set mode>
er Re
S
cann ad
X
X
X
X
XX
S✳ canne r Read y
03-Chap. (1) 98.2.20, 10:49 AM13