Filter
Top Products
7-2
Contents of the Setup Mode
This section describes the contents of the setup mode.
The setup mode can be classified into 17 (M3099EX/EH) or 18 (M3099GX/GH) types.
Contents
Set in EEPROM whether double feed detection is done or not.
Set in EEPROM the pattern No.of IPC-2 pre-set mode.
Reset the abrasion counter after Belt/Roller are exchanged.
Set in EEPROM whether the buzzer function is on or off.
Set in EEPROM whether pre-picking is done for fast reading or not.
Set in EEPROM the LCD contrast.
Set in EEPROM whether pick speed is fast or slow.
Set the initial number. The set value can be stored in EEPROM.
Set in EEPROM whether the number is reset by hopper empty detection.
Reset the number to the initial value.
Reset the ink counter after the print head is replaced.
Set the transfer rate in EEPROM. (1200/2400/4800/9600).
Set the SCSI-ID. (0-7)
Set the Product-ID. (M3096G/M3099G/M3099GH)
Set in EEPROM the time from when the hopper empty sensor is blocked
in manual mode until picking begins.
Set the time from when picking begins until the SF1 sensor is blocked by
paper.
Set the time from when a command is issued in manual mode until paper
is actually detected.
Set the time from when Start Command Time-out limits until hopper table
is lowered.
Set in EEPROM whether heater control is on or off.
*1 Available for only M3099EX/EH.
*2 Available for only M3099GX/GH.
Mode Setup type
1 Setting double feed detection
2 Setting IPC-2 pre-set
3 Reset of abrasion counter
4 Setting buzzer
5 Setting pre-pick
6 Adjusting LCD contrast
7 Setting pick speed
8 Setting initial value of endorser
9 Setting reset method of endorser reset
10 Reseting of endorser
11 Reseting of ink counter
12 Setting RS-232C transfer rate *1
13 Setting SCSI-ID *2
14 Setting Product-ID *2
15 Setting picking start time
16 Setting picking time
17 Setting time-out limit
18 Setting hopper time
19 Setting heater control
15-Chap. (7) 98.2.20, 10:56 AM2