Filter
Top Products
SPARC Enterprise M8000/M9000 Servers Product Notes 19
6522017 DR and ZFS may not be used in the same
domain.
Reduce the amount of kernel memory that ZFS
can allocate by setting the zfs_arc_max
parameter in the /etc/system file. The
following example sets the maximum size to
512 Mbytes.
set zfs_arc_max = 0x20000000
6522433 After the CPU hardware error occurred, the
fmdump(1M) command on the domain may
display an incorrect faulty component.
Check system status on XSCF.
6527781 The cfgadm command fails while moving the
DVD/DAT drive between two domains.
There is no workaround. To reconfigure
DVD/Tape drive, execute reboot -r from
the domain exhibiting the problem.
This bug has been fixed in Solaris 10 8/07.
6527811 The showhardconf(8) command on the XSCF
cannot display PCI card information that is
installed in External I/O Expansion Unit, if the
External I/O Expansion Unit is configured
using PCI hotplug.
There is no workaround. When PCI card in the
External I/O Expansion Unit is configured
using PCI hotplug, the PCI card information is
displayed correctly.
6529714 Warning messages occur while trying to
configure more than four X4447A-Z or
X1027A-Z1 cards into one I/O Boat.
No workaround available at this time.
6530288 Ap_Id format may not be shown correctly by
cfgadm(1M) command.
None available at this time.
This bug has been fixed in Solaris 10 8/07.
6530753 Some of the PCI slots in the External I/O
Expansion Unit PCI slots are not displayed
during a normal boot operation.
Use one of the following operations to display
all of the PCI slots.
• boot -r (at open boot prompt)
• devfsadm -C (at Solaris prompt)
• cfgadm (twice at Solaris prompt)
6531036 The error message network
initialization failed appears
repeatedly after a boot net installation.
There is no workaround.
6531668 System hangs when executing parallel hot
plug operation with SP DR in suspend phase.
No workaround available at this time.
TABLE 4 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround