Filter
Top Products
28 SPARC Enterprise Mx000 Servers Administration Guide • April 2007
▼ To Configure the DSCP Network
1. Log in to the XSCF console with platadm or fieldeng privileges.
2. Type the setdscp command.
You can use one of two methods, as follows:
■ Use the setdscp command with the -y -i address -m netmask options:
For example:
■ Use the setdscp command with no options (interactive mode).
You are prompted to enter all the DSCP IP addresses sequentially. A command
output example of this interactive mode is:
i. For each prompt, press the Enter key to accept the displayed value, or type
a new value followed by the Enter key.
ii. To save your changes, enter Y. To cancel the changes, enter N.
3. Verify the operation with the showdscp command.
XSCF> setdscp -y -i address -m netmask
XSCF> setdscp -y -i 10.1.1.0 -m 255.255.255.0
XSCF> setdscp
DSCP network [0.0.0.0] > 10.1.1.0
DSCP netmask [255.0.0.0] > 255.255.255.0
XSCF address [10.1.1.1] > [Enter]
Domain #00 address [10.1.1.2] > [Enter]
Domain #01 address [10.1.1.3] > [Enter]
Domain #02 address [10.1.1.4] > [Enter]
Domain #03 address [10.1.1.5] > [Enter]
Domain #04 address [10.1.1.6] > [Enter]
Domain #05 address [10.1.1.7] > [Enter]
Domain #06 address [10.1.1.8] > [Enter]
Domain #07 address [10.1.1.9] > [Enter]
Domain #08 address [10.1.1.10] > [Enter]
...
Commit these changes to the database (y|n) ?