Filter
Top Products
Index
Fujitsu Internal Use Only
IN-4 C156-E224-01EN
SCSI terminating resistor mode 3-19
SCSI terminating resistor mode (CNH1)
3-19
sector address format 4-39
SEEK (10) command 4-35
SEEK (6) command 4-35
SELECTION phase 4-51
self-diagnostic function 6-1
SEND DIAGNOSTIC command 4-39
Sense Key 4-28
separator optical section 1-9
service clearance 3-10
service life 2-6, 6-3
service system and repair 6-3
setting 3-18
setting terminal 3-18
setting terminal (CNH2) 3-18
shape of setting terminal 3-13
shutter 2-9
shutter closed 2-8, 5-7
shutter open 2-8, 5-7
specification 2-1
spindle motor 1-9
standby mode 4-7
standby timer 4-7
start, stop and eject processing 4-24
START/STOP UNIT command 4-24
storage 3-23
surface temperature measurement point 3-2
SYNCHRONIZE CACHE command 4-36
SYNCHRONOUS DATA TRANSFER
REQUEST message 4-44
system ground 3-11
T
temperature at each measuring point
(reference) 3-4
temperature measurement point 3-1
temperature requirement and measuring
method 3-3
temperature requirement at measurement
point 3-3
temperature rise under several conditions
3-4
test program 6-2
TEST UNIT READY command 4-11
timing rule 4-46
timing specification 4-46
transfer in asynchronous mode 4-52
transfer in FAST SCSI mode 4-53
transfer mode setting requested by INIT to
ODD 4-45
transportation 3-23
type of message provided by ODD 4-42
U
unpacking 3-21
V
variable value in Caching page 4-19
variable value in flexible disk page 4-18
variable value in Power condition page
4-20
variable value in read-write error recovery
page 4-16
variable value in Verify control page 4-21
various process 4-4
various radio wave standard 1-4
VERIFY command 4-33
Verify control page 4-20
Verify mode 4-21
vibration resistance (shock resistance) 1-4
W
when drive power is off 5-3, 5-5
when drive power is on 5-3, 5-5
when storing cartridge 5-10
when transporting cartridge 5-10
when using cartridge 5-9
wide operating environment 1-4
WRITE (10) command 4-34
WRITE (6) command 4-33
WRITE AND VERIFY 4-34
WRITE AND VERIFY command 4-34
WRITE BUFFER command 4-40
write cache feature 1-5
write cache mode 3-19
write cache mode setting 3-19
WRITE LONG command 4-41
write protect tab 2-9, 5-8
write/read test 6-2