Filter
Top Products
C156-E227-01EN IN-1
Index
128 MB media 2-12
1.3 GB media 2-12
230 MB media 2-12
540 MB/640 MB media 2-12
A
active mode 4-40
actuator section 1-8
adaptability 1-3
Address 4-3
air cleanliness 3-3
algorithm for alternate processing 2-12
allowable input voltage and current 3-13
alternate sector assignment criteria 4-37
appearance 1-6, 2-9, 5-6
appearance of optical disk cartridge 5-6
appearance of optical disk drive 5-1
ASC/ASCQ list 4-71
ATAPI controller circuit section (only for
optical disk drive USB2.0) 1-10
ATAPI-USB interface converter section
(only for optical disk drive
USB2.0) 1-10
Attached 4-2
automatic allocation of alternate data block
1-3
automatic alternate sector assignment
function 4-36
automatic spindle stop function 1-3
B
bit error rate after ECC processing 2-6
block diagram of control circuit section 1-9
Bulk-In 4-1
Bulk-Only Mass Storage Reset 4-27, 4-36
Bulk-Out 4-1
C
cable connection 3-14, 3-21
cable connection diagram 3-15
cable connector specification 3-14
cache function 4-38
caching page 4-55
capacity list header 4-65
cartridge case 2-10
catalog 2-1
CBW check 4-31
CBW format 4-29
center of gravity 3-10
changeable value in caching page 4-55
changeable value in drive operation mode
page 4-50
changeable value in flexible disk page 4-54
changeable value in removable block access
capabilities page 4-56
changeable value in timer and protect page
4-58
changeable value in the read-write error
recovery page 4-52
change of revision number in field 6-4
checking panel function 3-12
check to be made if initial operation check
terminates abnormally 3-22
cleaning kit 5-9
cleaning of disk surface 5-12
cleaning of optical disk cartridge 5-10
cleaning of optical disk drive 5-5
cleaning optical disk cartridge 5-8
cleaning tool for optical disk cartridge 5-8
Clear Feature 4-7
Code-ID 4-79
Command Block Wrapper (CBW) 4-28
Command Status Wrapper (CSW) 4-30
compatibility with international standard
(media interchangeability) 1-2
Configuration 4-18
configuration 1-7
Configuration descriptor 4-18
configuration of optical disk drive 1-6, 1-7
Configured 4-3
connection check 3-22
connector and terminal location 3-14
continuous block processing 1-4
control circuit section 1-8
CSW check 4-32
CSW format 4-31
current/maximum capacity descriptor 4-66
current waveform (+5 VDC) 3-13
current waveform (reference) 3-13
D
data buffer 4-38
data error detection criteria 4-37
data transfer between host and device 4-33
data transfer flow 4-31
Default 4-3
Default Control 4-1