Filter
Top Products
Installation Requirements
3-20 C156-E227-01EN
(3) Installation
a) While the power is on, do not connect or disconnect the connectors or change
the terminal settings.
b) While the power is on, do not move the drive.
c) Before moving the drive, first eject and remove any optical disk cartridge in it
andthenturnoffthepower.
Device damage: Before moving the drive, remove any optical disk cartridge in
it. If the drive is moved with the optical disk cartridge loaded in it, the head may
move back and forth in the drive to damage the head or disk, consequently
disabling data from being read later.
(4) Packing
a) Remove an optical disk cartridge from the drive before packing it.
b) Place the drive in an antistatic plastic bag with a desiccant (silica gel).
c) Fujitsu recommends using the same cushions and carton supplied by Fujitsu
with the drive. If they are not available, ensure the use of a carton with an
adequate shock absorbent structure that can prevent shock or vibration from
being directly applied to the drive. In this case, provide sufficient protection
on the printed circuit board unit surface and the interface connectors to avoid
damages.
d) Apply "UP" and "Handle With Care" labels to the outside of the package.
Figure 3.14 gives an overview of packing drives individually or in sets. Note that
different cushions of different forms and materials but with equivalent functions
maybeusedwhenpackingdrivesinthefuture.