41
User-Installable Features
Memory Upgrade
Module
Your Fujitsu LifeBook P1600 Series notebook comes with
a minimum of 512 MB of high speed Double Data Rate
Synchronous Dynamic RAM 2 (DDR2 SDRAM), 533
MHz factory installed. To increase your system’s memory
capacity, you may install a memory upgrade module. The
memory upgrade must be a dual-in-line (DIMM)
SDRAM module. To ensure 100% compatibility,
purchase the SDRAM module only from the Fujitsu web
store at www.shopfujitsu.com
.
REMOVING MEMORY MODULES
1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the system bottom side up, and remove the
screws of the memory upgrade module compart-
ment. (Figure 4-2)
4. Remove the cover.
Figure 4-2. Opening the Memory Upgrade Compartment
5. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
(Figure 4-3)
6. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook.
7. Store the memory module in a static guarded sleeve.
8. Install a new module as outlined in the procedure
below.
9. Replace the cover.
10. Replace the screws.
Figure 4-3. Removing a Memory Module
The system contains components that can
be severely damaged by electrostatic
discharge (ESD). To minimize risk to the
components, observe the following
precautions:
■
Be sure to power down your system
before adding or removing system
components. Even if the system is in
hibernate or standby states, data could
be lost or memory could be damaged if
power is still available to the system.
■
When installing or removing a memory
module, hold it by the edge so as not to
touch any contacts or chips. Be careful
not to touch any internal computer
terminals or components; the oil from
your fingers could cause a short to the
components.
Electrical equipment may be hazardous if
misused. Operations of this product or
similar products, must always be supervised
by an adult. Do not allow children access to
the interior of any electrical products and
do not permit them to handle any cables.
Do not remove any screws from the
memory upgrade module compartment
except those specifically shown in the
directions for installing and removing the
module.
Memory Compartment Cover
Memory Module
P Series.book Page 41 Monday, October 9, 2006 10:58 AM