Filter
Top Products
www.gateway.com
53
12 Carefully open the LCD panel, then remove the two front LCD hinge screws.
13 Lift the old LCD assembly off of the convertible notebook.
14 Place the new LCD assembly on the convertible notebook. Make sure that the antenna wires
and LCD cable are routed between the front hinge screw posts.
15 Replace the screws removed in Step 12.
16 Carefully close the LCD panel, then replace the screws removed in Step 11.
17 Open the LCD panel, then replace the grounding screw removed in Step 10.
18 Feed the antenna wires into the wireless bay.
19 Replace any tape that held the antenna wires and LCD cable.
20 Replace the system board by following the steps in “Replacing the system board” on page 35.
21 Replace the palm rest by following the steps in “Replacing the palm rest” on page 25.
22 Replace the hinge cover by following the steps in “Replacing the hinge cover” on page 23.
23 Replace the hard drive by following the steps in “Replacing the hard drive” on page 17.
24 Replace the DVD drive by following the steps in “Replacing the DVD drive” on page 14.
25 Reconnect the antenna wires to the wireless card by following the steps in “Replacing the
IEEE 802.11 wireless card” on page 10.
26 Replace the memory bay cover by following the steps in “Adding or replacing memory
modules” on page 6.
Screw Screw