Filter
Top Products
www.gateway.com
57
Adding or replacing a
hard drive
To add or replace a hard drive:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 47.
2 Slide the drive slot’s release latch toward you to unlock
it (or it may already be unlocked).
3 If you are adding a new drive, go to Step 6.
- OR -
If you are replacing an existing drive, go to the next step.
4 Disconnect the drive cables, noting their locations and
orientation. (You will reconnect the cables after you
install the new drive.)
SATA power cable SATA data cable
8513162.book Page 57 Tuesday, May 20, 2008 4:09 PM