Filter
Top Products
GE Energy Services
BECCO2200 DCA
Configuration Guide
A164-0CG-1.00-2 Restricted
14
Full
Field Range Special Typical
Type 2 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Type 3 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
Use Type 7 Read
Instead
-1
Type 4 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Type 5 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Type 6 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Type 7 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Type 8 Read Interval
(seconds)
< 0 - Demand Only
= 0 - Continuous
> 0 - Interval
N/A 10
Time Synchronization
Interval (seconds)
£ 0 - Demand Only
> 0 - Interval
N/A 600
5.2.1 Remote Address
This parameter specifies the remote address programmed at the unit. Each unit on the same
communication port must be given a unique address. -1 is used to indicate a SPARE device.
Spare devices are allocated WESDAC points, as described in Chapter 2: but no communication
is ever initiated to the device.
5.2.2 Unit Type
This parameter specifies the type of unit. Only BECO2200-M-0420 Control Relay is supported.
5.2.3 Type 0 Read Interval
This parameter specifies, in seconds, the minimum interval between Type 0 Read requests issued
to the device. A negative number configured indicates that no timed scans of this type are
required for this device. The device may, at any time, be scanned through the activation of the
Type 0 Read Pseudo Control.