GE ML1600 Switch User Manual


 
CHAPTER 12: SPANNING TREE PROTOCOL (STP) CONFIGURING STP
MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 12–5
Example 12-2 illustrates the show stp command with the ports parameter. The variables
listed in this example are defined as follows:
Port#: indicates the port number. Value ranges from 01 to max number of ports in the
switch
Type: indicates the type of port - TP indicates Twisted Pair
Priority: STP uses this to determine which ports are used for forwarding. Lower the
number means higher priority. Value ranges from 0 to 255. Default is 128
Path Cost: This is the assigned port cost value used for the switch to determine the
forwarding points. Values range from 1 to 65535
State: indicates the STP state of individual ports. Values can be Listening, Learning,
Forwarding, Blocking and Disabled.
Des. Bridge: This is the port's designated root bridge
Des. Port: This is the port's designated root port
To enable or disable STP, enter the STP configuration mode via the
stp command and use
the
stp enable or stp disable command.
To
stp command enters STP configuration mode:
stp
The
enable and disable parameters start (enable) or stop (disable) STP.
stp <enable|disable>
The
stp and rstp parameters set the spanning tree protocol to be IEEE 802.1d or 802.1w
(Rapid Spanning Tree Protocol).
set stp type=<stp|rstp>
The
show active-stp command display which version of STP is currently active.
show active-stp
Note
Incorrect STP settings can adversely affect network performance. GE recommends starting
with the default STP settings. Changing the settings requires a detailed understanding of
STP. For more information on STP, please refer to the IEEE 802.1d standard.
Example 12-2: Viewing STP ports
ML1600#
show stp ports
STP Port Configuration
--------------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
--------------------------------------------------------------------------------------
09 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:09
10 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0a
11 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0b
12 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0c
13 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0d
14 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0e
15 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:0f
16 TP(10/100) 128 100 Disabled 80:00:00:20:06:25:ed:80 80:10
ML1600#