Filter
Top Products
1–10 MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
COMMAND LINE INTERFACE SOFTWARE CHAPTER 1: INTRODUCTION
Note
If the ML1600 is not connected to a network, then proceed to Step 3 below. or use the
default IP address.
Step 1:
The ML1600 will scan the network for a DHCP server. If the server responds, the ML1600
will acquire and set the assigned IP address. To manage the switch, determine the
assigned IP address and enter as follows in Internet Explorer:
https://
<assigned_IP_address>
Ensure that https is entered, not http, and that there is connectivity (that is, you can ping
the switch).
Step 2:
If there is no response from a DCHP server, the ML1600 will query for a BOOTP server. If the
server responds, the ML1600 will acquire and set the assigned IP address. To manage the
switch, determine the assigned IP address and enter as follows in Internet Explorer:
https://
<assigned_IP_address>
Ensure that https is entered, not http, and that there is connectivity (that is, you can ping
the switch).
Step 3:
If there is no response from either a DCHP or BOOTP server, or if the switch is not
connected to a network, the switch will assign itself an IP address. The ML1600 will check
to see if IP address 192.168.1.2, with a network mask of 255.255.255.0, is free. If so, it will
assume these values. If this IP address is assigned to another device, the ML1600 will
repeat steps 1 through 3 to find a DCHP or BOOTP server or wait for the 192.168.1.2
address to become free.
Once connected, the browser will display a login prompt. The default login is:
•Username: manager
Password: manager
1.5.6 Setting the IP Parameters
To setup the switch, the IP address and other relevant TCP/IP parameters have to be
specified.
The IP address on the MultiLink switch is set to 192.168.1.2 from the factory. The switch is
fully operational as a Layer 2 switch as a default. Setting a default IP address can
potentially cause duplicate IP address problem if multiple switches are powered on and
installed on the network. To manage the switch, an IP address has to be programmed.
Before starting, please ensure that the IP address assigned to the switch is known or
contact your system/network administrator to get the IP address information. Follow the
steps listed below to configure the switch.
Z Ensure the power is off.
Z Follow the steps described above for connecting the console cable
and setting the console software.
Z Power on the switch.