Filter
Top Products
CHAPTER 16: SNMP CONFIGURING SNMP THROUGH THE COMMAND LINE INTERFACE
MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 16–7
Example 16-1: Configuring SNMP
ML1600#
set snmp type=v1
SNMP version support is set to "v1"
ML1600# show snmp
SNMP CONFIGURATION INFORMATION
------------------------------
SNMP Get Community Name : public
SNMP Set Community Name : private
SNMP Trap Community Name : public
AuthenTrapsEnableFlag : disabled
SNMP Access Status : enabled
SNMP MANAGERS INFO
------------------
SNMP TRAP STATIONS INFO
-----------------------
ML1600# set snmp type=all
SNMP version support is set to "v1, v2c, v3"
ML1600# show snmp
SNMP v3 Configuration Information
=============================
System Name : ML1600
System Location : Markham, ON
System Contact : multilin.tech@ge.com
Authentication Trap : Disabled
Default Trap Comm. : public
V3 Engine ID : Multi_Switch_Engine
ML1600# snmpv3
ML1600(snmpv3)##
setvar sysname=ml1600 syscontact=admin syslocation
=
ML1600(snmpv3)# quickcfg
This will enable default VACM.
Do you wish to proceed? ['Y' or 'N' ] Y
Quick configuration done, default VACM enabled
ML1600(snmpv3)## engineid string=Multi_2400
Engine ID is set successfully
ML1600(snmpv3)## authtrap enable
Authentication trap status is set successfully
ML1600(snmpv3)## show-authtrap
Authentication Trap Status: Enabled
ML1600(snmpv3)## deftrap community=mysecret
Default trap community is set successfully
ML1600(snmpv3)## show-deftrap
Default Trap Community : mysecret
(continued on next page)