Filter
Top Products
17–26 MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
COMMAND REFERENCE CHAPTER 17: MISCELLANEOUS COMMANDS
The Simple Mail Transfer Protocol (SMTP) commands for e-mail are shown below. Refer to
E-mail on page 17–6 for additional details.
•
add: adds a recipient
•
delete: deletes a recipient
•
help smtp
•
sendmail: sends e-mail
•
server: sets the global SMTP server configuration
•
smtp: enables/disables SMTP e-mail alert
The Simple Network MGMNT Protocol (SNMP) commands are shown below. Refer to SNMP
on page 16–1 for additional details.
•
authentraps: enable/disables the authentication traps
•
community: configures SNMP community names
•
help snmp
•
mgrip: adds or deletes the SNMP manager IP
•
setvar: configures system name, contact, or location
•
traps: adds or deletes a trap receiver
The Simple Network Time Protocol (SNTP) commands are shown below. Refer to Network
Time on page 5–10 for additional details.
•
delete: deletes the SNTP server from SNTP server database
•
help sntp
•
setsntp: adds SNTP server into the SNTP server database
•
sntp: configures parameters for SNTP system
•
sync: sets the interval for synchronization time with an NTP server
The Spanning Tree Protocol (STP) commands are shown below. Refer to Spanning Tree
Protocol (STP) on page 12–1 for additional details.
•
cost
•
lll
•
port
•
priority
•
s-ring
•
stp
•
timers
The user commands are shown below. Refer to the User MGMNT on page 1–12 for
additional details.
•
add: adds a new user
•
chlevel: changes the user access permissions
•
delete: deletes an existing user
•
help user
•
passwd: change the user password
•
tacplus
•
tacserver