Filter
Top Products
16–6 MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CONFIGURING SNMP THROUGH THE COMMAND LINE INTERFACE CHAPTER 16: SNMP
trap <add|delete> id=<id> [type=<v1|v2|inform>] [host=<host-ip>]
[community=<string>] [port=<1-65534>]
The show-trap command shows the configured trap stations in tabular format. The
id
argument is optional and is the number corresponding to the trap entry number in the
table.
show-trap [id=<id#>]
The
com2sec command specifies the mapping from a source/community pair to a
security name. Up to 10 entries can be specified. This part of the View based Access
Control Model (VACM) as defined in RFC 2275.
com2sec <add|delete> id=<id> [secname=<name>] [source=<source>]
[community=<community>]
The
group command defines the mapping from sec model or a sec name to a group. A
sec model is one of v1, v2c, or usm. Up to 10 entries can be specified. This part of the View
based Access Control Model (VACM) as defined in RFC 2275.
group <add|delete> id=<id> [groupname=<name>] [model=<v1|v2c|usm>]
[com2secid=<com2sec-id>]
The
show-group command displays all or specific group entries. The id argument is
optional and is the number corresponding to the group entry number in the table
show-group [id=<id>]
The
view command defines a manager or group or manager stations what it can access
inside the MIB object tree. Up to 10 entries can be specified. This part of the View based
Access Control Model (VACM) as defined in RFC 2275
view <add|delete> id=<id> [viewname=<name>] [type=<included|excluded>]
[subtree=<oid>] [mask=<hex-string>]
The
show-view command display all or specific view entries. The id argument is optional
and is the number corresponding to the view entry number in the table.
show-view [id=<id>]
The
user command adds user entries. The ML1600 allows up to 5 users to be added.
Currently, the ML1600 agent only support
noauth and auth-md5 for v3 authentication and
auth-des for priv authentication.
user <add|delete> id=<id> [username=<name>] [usertype=<readonly|readwrite>]
[authpass=<pass-phrase>]
[privpass=<pass-phrase>] [level=<noauth|auth|priv>] [subtree=<oid>]
The
show-user command displays all or specific view entries. The id is optional and is the
number corresponding to the view entry number in the table.
show-user [id=<id>]
16.2.2 Example
The following example shows how to configure SNMP.