Filter
Top Products
11 - 2 IMAGETEAM™ 2020/4620 System Manual
Imager Report
Scan the bar code below to generate a report for the connected imagers. The
report indicates the port, work group, imager name, and address. To assign a
name to your imager, refer to "Menu Command Syntax" on page 12-1.
Imager Address
Scan the bar code below to determine the address of the imager you are using.
Base Address
Scan the bar code below to determine the address of the base you are using.
Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want the standard product default settings restored,
scan the
Standard Product Default Settings: Current Application Group
bar
code below.
The Menu Commands starting on page 12-6 list the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the imager and the base to
perform a reset and become unlinked. Refer to "Imager Modes" on
page 3-5 for additional information.
Imager Report
Imager Address
Base Address
Standard Product Default Settings:
Current Application Group