Filter
Top Products
3 - 6 IMAGETEAM™ 2020/4620 System Manual
Open Link Mode - Single Imager
When newly shipped or defaulted to factory settings, the base and imager are not
linked. By placing an imager into the base, they establish a link. Placing a
different imager into the base establishes a new link and the old imager is
unlinked. Each time an imager is placed into the base, it becomes the linked
imager; the old imager is unlinked.
Override Locked Imager
If you need to replace a broken or lost imager that is linked to a base, scan the
Override Locked Imager bar code below with a new imager and place that imager
in the base. The locked link will be overridden; the broken or lost imager’s link
with the base will be removed, and the new imager will be linked.
Multiple Imager Operation
To put the imager in multiple imager mode, scan the bar code below. Once you
scan this bar code, the imager is unlinked from the base and must be placed into
the base to re-link.
Note: Multiple Imager Operation Mode allows you to link up to 7 imagers to one
base. You cannot join an eighth imager until you unlink one of the 7
imagers or take an imager out of range.
Open Link Mode
(Single Imager)
Override Locked Imager
(Single Imager)
Multiple Imager Operation