Filter
Top Products
IMAGETEAM™ 2020/4620 System Manual 3 - 11
Using the Imager with Bluetooth Devices
The IT4620 imager may be used either with the IT2020-5B base or with other
Bluetooth devices. Scanning the Non-Base Bluetooth Connection bar code
below allows the imager to be used with other Bluetooth devices (e.g., PDA, PC
- Bluetooth USB Adapter). After you scan the bar code below, follow the
instructions supplied with your Bluetooth device to locate the imager and connect
to it. If you go out of range with your imager, the imager automatically reconnects
to the Bluetooth device. If you want to re-link to the IT2020-5B base, refer to
"Single Imager Operation"
on page 3-5 or
"Multiple Imager Operation"
on
page 3-6
.
Note: The multiple work groups option is not available when you are using the
imager with Bluetooth devices other than the IT2020-5B base.
Changing Bluetooth PIN Code
Some devices require a PIN code as part of the Bluetooth security features. Your
imager’s default PIN is 1234, which you may need to enter the first time you
connect to your PDA or PC. The PIN code must be between 1 and 16 characters.
To change the PIN, scan the bar code below and then scan the appropriate
numeric bar codes from the Programming Chart inside the back cover of this
manual. Scan Save to save your selection.
Non-Base BT Connection
Bluetooth PIN