Filter
Top Products
2 - 8 IMAGETEAM™ 2020/4620 System Manual
Programming the Interface - Terminal ID Method
If your interface is not a standard PC AT, refer to Supported Terminals on page
2-9 through page 2-10, and locate the Terminal ID number for your PC. Scan the
Terminal ID bar code below, then scan the numeric bar code(s) from the
Programming Chart inside the back cover of this manual to program the imager
for your terminal ID. Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID bar code, then 0, 0, 3 from the Programming Chart inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the Programming Chart, scan
the Terminal ID bar code, scan the digits, and the Save code again.
Note: The default interface is Keyboard Wedge (Term ID = 003).
Note: After scanning one of these codes, you must power cycle your computer.
Terminal ID
Save