Filter
Top Products
IMAGETEAM™ 2020/4620 System Manual 11 - 3
Resetting the Standard Product Default Settings: All
Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands starting on page 12-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
Test Menu
When you scan the Test Menu
On
code, then scan a programming code in this
manual, the imager displays the content of a programming code. The
programming function will still occur, but in addition, the content of that
programming code is output to the terminal.
Note: This feature should not be used during normal imager operation.
Visual Menu 2003
Visual Menu 2003 provides the ability to configure a Hand Held Products imaging
device by connecting the imager to the COM port of a PC. Visual Menu 2003
allows you to download updates to an imager’s firmware, change programmed
parameters, and create and print programming bar codes. Using Visual Menu
2003, you can even set up the configuration for an imager which is not attached
to your PC. This enables one expert user to establish the configuration settings
for all the devices your company uses, then save these configuration files for
others. A configuration file can be e-mailed or, if you prefer, an expert user can
create a bar code (or series of bar codes) which contains all the customized
programming parameters, and mail or fax the bar code(s) to any location. Users
in other locations can scan the bar code(s) to load in the customized parameters.
Standard Product Default Settings:
All Application Groups
On
* Off